There wern’t any major problems, however, where parts were required (brakes) they are quite expensive – £75 for pads. The rest comes from service items (filters and so on), battery and a few bits and bobs.

Aside from the timing belt and lower engine mount it’s in good condition – fual gague and indicator stalk i will just live with as they are not major at all. I’ll source the engine mount in slow time and ring round the former MGR dealers on the Wirral for a price on a timing belt change.

In 3-6 months i’ll have the timing belt done, lower engine mount and front tyres. In 12 months time it should be well maintained and be looking good for a private sale (after a good solid clean and polish) or as a Part Ex car.

Not to mention that you can’t get timing/locking pins for it so that in 12 months time you can’t change the timing belt so it’s effectively worthless as if it goes, the engine is destroyed.

I can’t afford to flog it because i can’t afford to get anything else. It really makes my angry that my 220 is still parked outside the office – completely fine apart from the rear end damage and it’s going for scrap as soon as they can be bothered to get off their overpaid backsides and come and collect it.

I pulled onto the hard shoulder and stopped/started the engine a few times – made no difference. So i called the RAC. After he had bitched about my address being wrong (my permanant address is not on the Wirral) he looked at the car – fiddled with ignition coil/HT leads then connected his diagnostic tool. The OBD readout didn’t have any fault codes logged so we started the engine – was running fine.

It’s been fine ever since, i asked on the MG Rover owners forum and apparently one common fault is the connector for the throttle position sensor which would cause this sort of thing – so the solution is to cable tie it on, which i’ve now done. According to the service manual a few other things can cause it – ht leads, spark plugs, battery. ignition coil – most of which will get serviced/replaced next week. The battery definitely wants doing as it does feel a bit flat.

So that was that fun, hopefully just a minor glitch that won’t be a problem.

When i got home however, i was watching TV when it went bang – very loudly. Taking it to bits one of the regs has blown on the psu board so i’ve had to order a replacement PSU board, luckily only £35 delivered but still, damned annoying!. I’ll post with details on makes/model and fault when i get it sorted out.

Despite the car being well looked after – full service history from new at 10k mile intervals with all required work undertaken and absolutely no issues, that’s what they valued it at. So i spent some time using all the fuel and stripping it of useful components – the newish Bosch Silver battery, GPS receiver, phone charger/holder, head unit, tweeter speakers, floor mats and other bits and pieces, including the odd momento. It also took me a week to find a new car. I had a plan. I had heard the adverts on the radio for http://www.chapelhouse.co.uk/ – offering 0%/£0 deposit 5 year finance, perfect i thought. I looked at the website, found a couple of lovely Citereon C4 Coupe’s (i think they look amazing), well within budget – one at £7,000 or £116 per month.

So i toddled off to the showroom – “I’m afraid you don’t qualify for 0% finance sir, the total repayment will be almost £9,000″. Normally that would be fine(ish if you don’t mind being stiffed for interest) but similar specification C4′s were on autotrader for £4.5-5k, i had assumed they’d just inflated the cost of the car instead of charging interest, so they could offer 0%. I told them to stuff it, i wasn’t going to pay nearly double. I could have found another dealer, on high interest finance and bought it for around £7k. However, i didn’t have time. So we went trailing around all kinds of back end dodgy dealers before i found a car.

There’s no easy way to say this, it’s a….

Cityrover.

Phew, glad i got that out in the open, i am the not so proud owner of a Rover Cityrover, or rather a Tata Indica with a Rover badge. It’s saving grace is that it only cost £995 and it’s a 2004 car which has 12 months MOT and 6 months Tax. Other than that, theres not a lot else to it, it’s just a simple, basic runabout, hopefully one which works.

It’s not without it’s quirks (let’s be honest, it wouldn’t be a Rover if it all worked), the fuel gague only works properly when turning left and the indicators don’t click in but hey, it works!

Rover made a big mistake asking £7,700 for this car (Sprite model) when they were buying them from Tata in India for £2k and they sell over there for about £3.5k. If they’d just sold it at £4.5k then it would have been massively popular.

It’s going to the garage next wednesday for a service and inspection, watch this space for how much it’s going to cost. If it’s ok then i’ll be re-instating the car pc – it’ll be the most pimped up CityRover in existance!

Bye all for now

Just a quick note to say that i’m on the lookout for a new job, my skills and so on are details on my profile page here

If you know of anything going which I would be suitable for (preferably in the north west of the UK) then please feel free to let me know via email on dave@lewty.org.uk.

This has led me on to another system – XBMC, which i would say i can’t praise it highly enough, however, it has a massive flaw (for me), it doesn’t (yet) offer PVR/Live TV functionality – however, that is actually being developed as we speak and plugins are already available to use Myth, VDR and TV Headend (whatever that is). These arn’t as polished as they should be, but i don’t think it will be long before they are.

Once XBMC is mature with Live TV i will almost certainly migrate to it. I was very impressed with it – fully set up with the remote control – even connecting to network shares, auto meta data download for TV and film, ‘pooled’ TV/Film etc virtual directories (logically merge the contents for display). It does require a slightly different TV episode naming scheme however, but i think i can cope with doing that (use bulk rename utility – www.bulkrenameutility.co.uk).

At the moment i’m stuck with Windows 7 Mediacentre, which doesn’t playback properly because it can’t keep audio and video in sync…. (not a CPU load problem).

As for other things, i have reached the end of an era, all my servers, apart from the fileserver have been turned off. I originally put them in under the ‘professional development’ banner, enabling me to learn and expand my technical knowledge on a variety of systems. However the truth these days is i spend my PD time at home reading technical books and learning the theory instead of practical. To some extent i’m learning about problems which i have at work and so i apply the practical knowledge there instead.

Getting rid of things didn’t go entirely to plan – the mail was actually the easiest, i simply signed up to a hosted exchange account with www.simplymailsolutions.com their pre-sales staff were very helpful and it’s only £5.99/month (on the now ‘Classic’ package (was previously named standard when i signed up). I get 2Gb Exchange 2007 mailbox and a free copy of Outlook 2007 (both free upgraded to 2010 when they get around to it). It’s been great so far, no more pesky VPNs for checking my mail and Exchange 2007 instead of 2003 too which is a bonus.

As for the other servers, web hosting duties have been with TSOHost for over a year without issue but i needed somewhere to put my SVN server, at the moment it’s just file-based on the fileserver but that’s good enough for now. I’ve also lost the download box i had but it wasn’t really being used, PBX has also gone – no need for it really, it was just overkill to have in the house, i can always fire it up if i want to have a go with another version of Asterisk though.

The most difficult part of the migration was getting rid of the router VM, i thought i’d just be able to use the free Thomson speedtouch that came from my ISP – i logged in, had all the right options – WPA2, editable DHCP server, but it’s no so much lacking in features as…broken, i tried to configure the DHCP server and unless i wanted it on 192.168.1.0/24 there was basically no chance, it just wouldn’t work properly. So i put it in bridge again and used my DD-WRT/Linksys WRT54G device as the router/gateway with DNS, DHCP and wireless. A bit annoying that it’s a two box solution and i wanted one, but nevertheless it’s solved.

All of this has brought my background electricity useage down from over 600W to less than 200W (this being the fridge/freezer/switches/fileserver). My eventual plan is that if a new version of Opensolaris is ever released, i will upgrade the fileserver and put a VirtualBox, CentOS VM on it which will handle downloads and SVN, but Opensolaris is looking iffy at the moment and i may have to migrate – i considered a dedicated NAS but i also want to run SVN and things, maybe an Atom based system would be a better idea.

All this is in the aim to cut down the amount of stuff i use on a day to day basis so i could place it into storage as i’m planning on moving from my 3 bedroom house into a 1 bedroom apartment to save money, placing everything that won’t fit into storage (i have a lot of stuff). One quote i had for storage was £50/month for 50sq feet for a min of 6 months, which isn’t bad at all, i don’t think i’ll need that much so it should be even cheaper.

CarPC wise, the software is finished (more or less) i just need to sort out a battery for the laptop before i re-fit it into the car, i’ve already re-fitted the radio as i wanted to be able to play MP3 CDs, but i need to fit the laptop, USB Hub and Car2PC adaptor, i’ll attempt to make it a better job this time instead of all just shoved behind the dash.

Anyway, i think that’s about it, i tried to cover everything as i don’t blog anywhere near enough about the detail of some of my projects.

I’ve always been wrong, since 2005, every time i have tried it i’ve hard problems with hardware support, flaky software, wobbly codecs and so much more that is just hasn’t been worth the effort with Windows Media Centre outperforming it in every regard.

However, today i tried MythBuntu 2010.04 and finally, finally, it works. I still think the setup is far too complex – a simple tuner wizard would suffice and for sat tuners it should download the transponder information automatically. As of writing it’s currently broken – my DVB-S2 tuner doesn’t work – it’s detected but it wont scan for any channels in Myth (DVB Tools manages ok) and now it all seems to have fallen apart.

However, when it was working i had dual tuner DVB-T, in-band guide information, fast and smooth playback of MKV 1080p, (and everything else) as well as DD and DTS passthrough to my AV amp.

For the first time ever, i think it will be worth the effort to get working fully and look nice, so i can take advantage of multi-channel single-mux recording on one tuner and the front-end back-end design.

Watch this space.

AHA! EDIT:

After a reboot and re-configure of the tuners from scratch my sat tuner appears to be tuning! Fantastic, will report back if i get to see the channels and if BBC HD etc is working nicely.

EDIT 2:

Just had BBC HD running and looking lovely, however it was stuttering – another process on the box has excessive CPU i’m trying to trace down why, it appears not to be uncommon, but hey, the headline features of the system work which is a major first!

I extracted the battery and placed it safely outside in my yard, then i set about neutralising the acid left on the laptop chassis and docking station. Pictures attached…

Just what i needed of an evening.

Silverstone SST-LC17 Case
Seasonic S12-430
Intel Pentium D E2180 2x 2Ghz
Thermaltake AXP-140 Passive Heatsink
2GB DDR2 RAM
Asus P5B Mobo
Passive Geforce 9400GT GFX
Lite-On Blu-Ray Drive
Avermedia A16D Hybrid Tuner
Hauppage Mytv.t Tuner
160GB Seagate IDE HDD
Windows 7 Ultimate

If it wern’t for the HDD it would be completely silent, it’s made a massive difference – this system is in my lounge and it’s the only device which makes any noise at all. I’m undecided about the HDD solution – SSD would be ideal, but expensive as it’s the TV recording HD, so would require a good 128Gb at least really. I am probably going to try using a spare old 80GB SATA disk see if i can get away with it, if so i may be able to pick up a 64Gb SSD and problem will be solved. This also means i can head toward a smaller case in the future – the current one is 4U!

I may as well mention the blu ray, since i’m here. A bit disappointed to be honest, i had expected by now, that playback would be fully integrated into Windows Media Centre, however, it is not. The system wouldn’t even begin to play at first – just like the old Windows XP MPEG2/DVD problem. So i installed the enclosed Power DVD 8 BD and tried again – it just minimised Media Centre and launched PowerDVD – with a message saying it won’t run under 1024×768, FFS – my monitor is set at 720p of course it is, and how many other people will have done this!?! I was forced to raise it to 1080i whereby the text on the desktop looks awful, films look good though as does Media Centre. So now it runs, but not full screen, remote functions are basic at best.

So disappointed, i wanted the experience to be seamless, i’m strongly considering moving the drive to my PC and just ripping every film i get. It’s no wonder people pirate films, its a right pain to do it properly. On that subject, i was ripping my CDs – all originals. And i have a ‘Copy Controlled’ CD in my collection. Can’t rip it. Bloody annoying, i can pirate the album no problem, within minutes, but can i rip the CD? No. People who have paid full price for films and music are coming off worse. If it wasn’t such a pain then i wouldn’t mind – CSS on DVDs was never this problematic, sure you had MPEG2 licencing issues, but that was a different game.

Anyway, i’ve ranted long enough.

PS don’t pirate, support artists and film makes, buy CDs, DVDs and Blu-Rays (but use eBay and Amazon market place, don’t get ripped off!)